Scarlett Silver Line SC-HC63C11, Instruction Manual

Page: 5 / 36

IM022
www.scarlett.ru SC-HC63C11 5

In case of power cord is damaged, its replacement should be
done by the manufacture or service department or the other
high-skill person to avoid any danger.

Never try to repair this appliance by yourself. In case of failure,
contact the nearest seller.

Keep the cord away from sharp edges and hot surfaces.

Do not place or store the appliance where it can fall or be
pulled into a tub or sink.

Do not pull, twist, or wrap the power cord around the
appliance.

Never insert any objects into openings in the appliance
housing.

Do not put operating appliance on any surface, it may cause
injury or damage.

Do not use the appliance with damaged comb, or with teeth
missing from the blades as injury may occur.

NOTE: KEEP THE BLADES OILED.

Do not use the hair clipper when the skin is infected.

Do not use the hair clipper on animals.

If the product has been exposed to temperatures below 0ºC for some time it should be kept at
room temperature for at least 2 hours before turning it on.

The manufacturer reserves the right to introduce minor changes into the product design
without prior notice, unless such changes influence significantly the product safety,
performance, and functions.

Manufacturing date is indicated on the unit and/or on packing as well as in accompanying
documents in the following format XX.XXXX where first two figures XX is the month of
production, and following four figures XXXX is the year of production.
BLADE ALIGNMENT

Your clipper was carefully examined to ensure that the blades were oiled and properly aligned
before leaving our factory.

Blades must be realigned if they were removed for cleaning or after replacement.

To realign the blades, simply match the upper and lower blades teeth up, point for point.

End of top blade teeth should be approximately 1.2 mm back from lower blade. Compare your
clipper blades with the sketch (pic.1).

If blade alignment is incorrect, add a few drops of oil to the blades, switch on the clipper for a
few moments, switch off and unplug. Loosen screws slightly and adjust. Tighten screws after
blade is aligned.
OILING

To maintain your clipper in peak condition, the blades should be oiled after every haircut.

Do not use hair oil, grease, oil mixed with kerosene or any solvent.
BLADE LEVER

The lever located to the left of the blades, allows easily adjust cut hair length while clipping.

The lever adds versatility to your clipper by allowing you gradually change the closeness of
your cut without an attachment comb.

When the lever is in the uppermost position, the blades will give you the closest cut and leave
the hair very short. Pushing the lever downwards gradually increases the cutting length.