Scarlett SC-SI30K47, Instruction Manual

Page: 5 / 40

IM022
www.scarlett.ru SC-SI30K47 5

If ironing is interrupted, stand the iron on heel rest only, do not
place the steam iron on metal or rough surfaces.

Iron should be used and stored on a flat, stable surface.

Iron should not be used if it is dropped, if there visible signs of
damage or if it leaks.

When placing the iron on its stand, ensure that the surface on
which the stand is placed is stable.

CAUTION: To avoid a circuit overload, do not operate another
high wattage appliance on the same circuit.

If the product has been exposed to temperatures be
low 0ºC for some time it should be kept at
room temperature for at least 2 hours before turning it on.

The manufacturer reserves the right to introduce minor changes into the product design
without prior notice, unless such changes influence significantly the product safety,
performance, and functions.

Manufacturing date is indicated on the unit and/or on packing as well as in accompanying
documents in the following format XX.XXXX where first two figures XX is the month of
production, and following four figures XXXX is the year of production.
IRON SOLEPLATE

The "Keramopro" soleplates are coated with the professional metal-ceramic coating
developed in collaboration with Scarlett specialists. The coating is characterized by an
enhanced level of strength, glide and 100% resistance to burning.
BEFORE THE FIRST USE

The device is designed for Ironing clothes and other fabric products.

Some parts of the steam iron have been slightly greased and as a result the iron may slightly
smoke when switched on for the first time. After a short time this will cease.
HOW TO USE
SETTING TEMPERATURE

Always check whether a label with ironing instructions is attached to an article to be ironed.
Follow these instructions in all cases.

Turn the temperature control dial round to set the appropriate temperature indicated in ironing
instructions or on fabric label.
LABEL TYPE OF TEXTILE
Do not iron this article
•
Synthetics, Nylon, Acrylics, Polyester, Rayon
••
Wool, Silk
•••
Cotton, Linen
Maximum temperature (Steam)

Insert the mains plug into the wall socket. The indicator light will turn on.

When the indicator light goes out you may start ironing

If you set the temperature control to lower setting after ironing at a high temperature, it is not
recommended to iron before the pilot light switches on again.
WATER TANK FILLING

Unplug the iron before filling the water tank.

Hold the steam iron in horizontal position.

Slowly pour water through the water inlet.

Do not fill higher than mark on the water tank, in order to avoid water spilling.
NOTE: Your steam iron is designed to use tap water. However, if the water is very hard, it is
advisable to use distilled water.

The opening which is used for pouring water should be closed when the iron is in use.

Always unplug the iron from the power socket when refilling the water reservoir.

Do not use chemically de-limed or perfumed water.

If you have too hard water,it is advisable to use only distilled or demineralized water.