Scarab SB Series, Owner'S Manual

Page: 78 / 182

Owner’s Manual Page 74 Boat Systems - Section B
Figure B49: Enclosed Head
(Applicable Models Only)
B. Porta-Potti
A porta-potti or porta-potti with pumpout is available
on certain Scarab models. A general guide on porta-
potti use is included in this section. Note: Models may
vary. Refer to the manufacturer’s literature included in
the owner’s packet regarding the use, care and
maintenance of the porta-potti if installed.
Porta-Potti Preparation:
Separate unit by sliding the locking lever to the left
“unlocked” position and hold (Figure B50-A). Separate
the units (Figure B50-B).
Figure B50 (A & B): Separate Porta-Potti
With the waste tank (lower section) sitting flat, open
valve by pulling handle out (Figure B51-A). Add
deodorant through the valve opening (Figure B51-B).
Use Thetford Holding Tank Deodorant (sample
included) in built-in storage compartment (Figure
B51-C). Add water to cover tank bottom. Close valve
and replace deodorant (Figure B51-D).
Figure B51 (A-D): Porta-Potti Preparation
Recombine the unit. Align hinge with front interlocking
tabs. To secure unit, press downward – it should click
into place.
Fill fresh water tank by removing the water fill cap and
filling the tank with fresh water (Figure B52). (NEVER
add holding tank chemical to the fresh water tank
assembly.) Replace and tighten the cap securely.
Figure B52: Filling Fresh Water Tank
NOTICE
Before each use: With seat cover closed, open
and close the holding tank valve (Figure B53­A
& B) to vent any pressure that may have built
up as a result of heat or altitude. This prevents
upward splashing of bowl contents when toilet
is flushed.
Figure B53 (A-C): Porta-Potti - Bellows Flush Operation
Bellows Flush Operation:
1. Pull out holding tank valve handle (Figure B53-B).
2. Push down on bellows to rinse the bowl. (Figure
B53-C).
3. Push valve handle all the way in to insure an
odor-tight seal.
C