Part No. SCAZ037886 8.6.00
26
E&OE
Merlin and Magnum Hydrostatic
Operating Instructions
Using the Dust Suppression System
Filling the water tank
Attach the appropriate coupling and water hose to the filler aperture
q
and fill
until the blue float reaches the top of the water level sight tube
w
(use clean
water).
Using the low pressure water system
The low pressure water is used on the, side brush(es), suction tube(s), and
central brush (wide sweep). To operate any of these functions the relevant
button(s) on the main panel must be selected when in sweep mode.
A shut-off valve is positioned between the water tank and the water strainer
and must be open when the system is in use
e
.
The side brush(es) are fitted with shut-off valves
r
.
It is vital that the water system is drained totally if the air temperature is
expected to fall to 0°c or below.
Fully draining the system -
Open tank drain valve
t
. Open low pressure water
shut off valve
e
. Open water strainer valve
u
. Open all brush shut-off valves
r
. When the water has stopped draining from the various taps. Shut valve
e
and remove the water strainer
y
. Start the engine and put into sweep mode,
activate all the low pressure water functions on the main control panel. When
the water has stopped flowing from the spray nozzles, turn off all the low
pressure water functions from the main control panel and exit from sweep
mode. Switch the engine off.
Due the customers requirements, other water features may be present but
not mentioned in this publication.
7
1
2
5
4
3
6
7
