Part No. SCAZ037886 8.6.00
13
E&OE
Merlin and Magnum Hydrostatic
Operating Instructions
Hopper remote control switch box functions
The hopper Raise/Lower and rear door Open/Close switches are located on the remote control box. This
is stowed in the cab, between the driver’s seat and door and is connected to a socket via a coiled lead.
In the interest of health and safety and to avoid possible damage to the sweeper or adjacent
structures, it is essential that the remote hopper/door controls are not activated from within the
cab. Always use these controls outside of the vehicle from a vantage point that affords a good view
of the sweeper and its immediate surroundings.
The hopper prop must always be in the deployed position when working under a raised hopper.
Failure to do so could result in serious injury.
The door prop must always be used when working under a raised rear door.
Hopper Raise
- Press and hold down to raise the hopper.
Hopper Lower
- Press and hold down to lower the hopper.
Rear Door Open
- Press and hold down until the door is Fully open (at approximately 90° to the rear
face of the hopper).
Ensure that the suction fan is OFF. The door cannot open while the fan is running due to the low
pressure created within the hopper.
Rear Door Close
- Press and hold down until the door is fully closed and the latching cycle has
finished.
Option
SAFETY INTERLOCK
This switch must be
pressed in and held before
any of the control
switches are operated.
