Installing i-on Control Units
Page 39
Step 8: Connect the mains cable
WARNING:
ENSURE THAT THE MAINS SUPPLY IS DISCONNECTED AND ISOLATED.
Connect the mains cable to the terminal block (Figure 22) and fit a strain-relief tie.
Do not apply power until after the lid is re-fitted.
Figure 22. i-onG3MM: Mains connections
Step 9: Re-fit the lid, switch on and configure the system
WARNING:
During initial power-up, keypad sounders and any internal loudspeaker may
give an alarm tone. If you are working at the top of a ladder, make sure that the sudden
noise does not startle you and cause a fall.
Re-fit the lid (Figure 23), then switch on the mains supply to the control unit.
Figure 23. i-onG3MM: Re-fitting the lid
Go through the initial configuration prompts and set up the system as described in the
Configuration Guide
. You are prompted to specify installer and user codes during initial
system configuration.
It is recommended that you connect the control unit to the internet and enable “Level 4
Update” in the installer and user menus. When you enter your installer code, the system
can then check online whether later versions of the firmware or language file exist, and
prompt you to install them. Please refer to the
Configuration Guide
for further details.