Scantronic 9800, User Manual

Page: 13 / 30

- -
Unsetting the System
On entering the premises the sounder will be emitting a continuous tone. The
user should proceed immediately to the keypad via the prescribed entry route
and unset the alarm as follows:
(a) (b)
A
B
C
OMIT day
Prog log
chime bell-test-walk
POWER
CLEAR
FAULT
9800
1 2 3
4 5 6
7 8 9
0
A
B
C
OMIT day
Prog log
chime bell-test-walk
POWER
CLEAR
FAULT
9800
1 2 3
4 5 6
7 8 9
0
OMIT SERVICE OMIT SERVICE
Enter access code within the
preset entry time.
System unset.
Note: If unsetting from Part Set, the ‘B’ or ‘C’ LED will be illuminated at
step (a). If zones have been omitted on setting, the omitted zone number will
be displayed at step (a). If a keyswitch is fitted, the system is unset by turning
the keyswitch off.
Exceeding the Entry Time
If the alarm system is not unset before the expiry of the preset entry time, the
internal sounder will change to emit a high pitched tone. You have not
caused a full alarm and still have the time of a second stage timer (30
seconds).
On expiry of the second stage timer, the system will enter into a full alarm
state. If your system is fitted with a remote signalling device, a signal will be
transmitted automatically to your alarm company central station, and the
police authority will be contacted.
IMPORTANT NOTE
If the full alarm condition has been caused by a delay in unsetting the
system and an automatic signalling device is fitted to your alarm system,
you must contact your alarm company immediately in order that the police
call can be cancelled.
11