Enter
Go To Control
Building
Panel
?
?
?
?
Zone
Tamper
Panic
Reset any panic buttons
activated, then
?
?
?
?
?
?
?
?
Zone
Service
"beep"
?
"beep"
"beep"
"beep"
?
?
?
EE
1
EE
1
EE
1
EE
1
Z1
2
Z1
2
Z1
2
Z1
2
Z2
3
Z2
3
Z2
3
Z2
3
Z3
4
Z3
4
Z3
4
Z3
4
Z4
5
Z4
5
Z4
5
Z4
5
Z5
6
Z5
6
Z5
6
Z5
6
Z6
7
Z6
7
Z6
7
Z6
7
Z7
8
Z7
8
Z7
8
Z7
8
Tamper
9
Tamper
9
Tamper
9
Tamper
9
3
6
0
9
Reset Code
AFTER AN ALARM
Fire Alarm: The system gives a fire alarm by
sounding a warbling tone from the internal sounder.
1. Evacuate the premises and call the Fire Brigade.
Do not attempt to unset the alarm.
2. When the premises are safe, follow the instruc
tions below.
To switch the bells off: Key-in your user code.
The sounders will stop and the zone light(s) for the
detectors that triggered the alarm will glow.
Tamper or Panic Alarm: If you hear the internal
sounder when the system is off then look at the
control panel:
If the Tamper light glows then key-in your user code
to stop the sounder. Call your alarm installer for
service.
If the tamper light is off see if a PA zone light is
glowing. Deal with the cause of the alarm first. Next,
reset the panic button, then switch the alarm system
bells off and reset the system (see below).
Reset system: You must reset the system before it
can be used again. If the Service LED is OFF then
you can reset the system yourself. Key-in your
access code again. All the zone lights should go off.
The system is now ready for use.
If the Service LED is ON, you must call for an
engineer to reset the system.
Remote Reset: If your alarm is connected to a
central station then the system may use remote
reset (ask your Installer). With this method the
keypad displays a special four digit code. Report
this code to the central station, who then give you
another code to let you to reset the system. Have a
pencil and paper ready to note down the code.
1. Key in your user code to silence the bells.
The display shows the zone and Service LEDs ON.
2. Key in your user code again.
The display shows a four digit code by lighting the
zone lamps one at a time. The small numbers to the
right of the lamps give the digits. The keypad
sounder gives a short tone each time the digit
changes. (If there is no light glowing then the digit is
“zero”.)
3. Note down the code. If necessary, press Enter to
make the keypad repeat the code.
4. Report the code to the central station.
496281 Issue 1
2
