20
11.4 END SANDING ON THE SANDING BELT
It is more convenient to sand the ends of long
workpieces with sanding belt in a vertical position.
See “Basic Operation – Positioning Belt Bed” for
adjusting the belt bed, and see “ Assembly –
Installing Table Assembly” for adjusting worktable.
Move the work evenly across the sanding belt. For
accuracy, use a miter gauge ( accessory).
11.5 SANDING CURVED EDGES
Always sand inside curves on the idler drum as
shown.
WARNING:
Never attempt to sand the ends of a
workpiece on the idler drum. Applying the end of the
workpiece to the idler drum could cause the
workpiece to fly up and result in a injury.
12. BASIC OPERATION
Always sand outside curves on the left side of
center on the sanding disc as shown.
WARNING:
applying the workpiece to the right
side of the disc could cause workpiece ti fly up
(kickback) and result in an injury.
12.1 SANDING SMALL END SURFACES ON THE SANDING DISC
.
NOTE:
Use of a Miter Gauge (optional accessory)
is recommended for this operation.
Always move the work across left side of center on
the sanding disc face as shown.
WARNING:
Applying the workpiece to the right
side of the disc first could cause workpiece to fly
up (kickback, and result in an injury
Summary of Contents for 48
Page 24: ...24 14 REPAIR PARTS ...
