10
2.2.g The belt grinder is prepared
This section concerns users who accessed the belt grinder and aggregate as a set. If you
have already a prepared belt grinder you can jump to the next section 2.2.h.
The belt grinder is in standard delivered equipped with a speed motor with motor brake,
switches (X) with overload relays, zero voltage poles, and coupled to the desired voltage.
! The electrical connection must be performed by a licensed electrician. It should be
verified that the motor (and possibly the ventilator) has the correct rotation (see the arrow
on the motor).
2.2.h Preparation before use.
Before use, eye protection, suction hoses and dust bag should be mounted. Clamps for
installing the suction hose is found in the dust bag. Eye protection (A) should be mounted
in the eye protection bracket (see Fig.: 2.2.1). Check that the aggregate does not touch the
belt.
Fig. 2.2.5 Belt grinder with attached RB aggregate 150
2.2.i Handle adjustment of the belt straight way
The following justification is swiftly done with handle D in case of receiving the belt grinder
and RB aggregate as a set. The other way of adjusting belt straight way was handled at
the production site. Therefore it is possible to start the grinder and control that it is running
straight and stable as follows:
1. Turn the contact wheel (E) by hand and adjust the belt with the handle (D) until it
runs straight.
2. Start the engine carefully and fine tune again with the handle.
E
A
D
X
