SCANMASKIN SCAN DUST BLASTCLEANER, Manual

Page: 26 / 41

26
www.scanmaskin.com
4 MAINTENANCE
4.1 Belt drive
The belt drive has to be tightened periodically. Remove the belt guard underneath the motor and the
ventilator. Loosen the four screws which fix the motor (47). Picture below. Only loosen the screws, do
not remove them. Loosen the nuts and turn the two tensioning screws clockwise until the belt has the
correct tension. The belt should not move more than one centimetre half way in between the pulleys.
Figure 1-2: Belt tensioner
4.2 Compressor
The oil level of the compressor (53) has to be checked and the water inside the tank has to be emp-
tied regularly. The dust filter needs to be cleaned on a weekly basis. All necessary information is given
in the compressor manual in the appendix.
4.3 Water Seperator
The water separator (57) separates the water from the compressed air and makes sure that no water
will be pressed inside the filter cartridges. The separator has to be checked on a regular basis and
the tank has to be emptied when full. The speed with which the tank fills with water depends on the
moisture of your location. To empty the tank open the valve on the bottom side of the separator.
4.4 Filter cartridges
If the performance of the Scan Dust blastcleaner is not sufficient any more or if the filtration is no long-
er dust free the filter cartridges (3) have to be checked.
Before removing the cartridges, the dust collector must be switched on for a while without sucking