SCANMASKIN SC-330 3, Manual

Page: 52 / 62

Scan Combiflex 330 – Manual
- - 50
5.4 Grinding disc replacement / assembly
Follow these steps to replace the Scan-On plate
§
Make sure the machine is in its “Safety off position”
§
Tilt the machine backwards and secure it.
§
Remove any tools used according to”
4.8 Changing tools
”.
§
Remove the three nuts that are tightened under the three screws holding the Scan-On plate.
§
Loosen the three screws holding the Scan-On plate.
§
Replace the Scan-On plate.
§
It’s recommended that new screws are used to fasten the replacement Scan-On plate.
§
It’s also recommended that copper paste is used on the surface of the screw hole at the Scan-On
plate.
§
Tighten all screws by hand and make sure that they are secured.
§
Use new nuts to secure the screws underneath the Scan-On plate.
5.5 Cleaning the machine
Before starting to clean the machine, make sure it is in ”Safety off position”.
The power must not be connected while cleaning the machine.
Do not use highly pressurized water to clean the machine.
Water and soap is recommended.
5.6 Trouble shooting
5.6.1 Common faults
Symptom Cause Correction A
5
The machine won’t start
§
There is a power failure from the power supply
§
Inspect the fuses in the worksites fuse box
§
Inspect cables
§
Measure that the main voltage is present and at full voltage
at the cable end near the machine.
O
E
E
The machine only operates
while the start button is
depressed
§
The motor is overheated
§
Wait until the motor is cool again O
§
The control device is damaged
§
Replace the control device S
The machine is weak and
might stop when on the
ground.
§
There is a voltage drop at the power supply
§
Inspect the fuses in the worksites fuse box
§
Inspect cables
§
Measure that the main voltage is present and at full voltage
at the cable end near the machine.
§
Make sure that the cable is not too long. If the cable should
be too long, use a cable with higher rating to a distribution
box nearer the machine.
O
E
E
O
The machine vibrates a lot
§
The grinding speed is to high
§
Lower the speed, only on machines with variable speed. O
§
The tools are damaged
§
Inspect the tools
§
Change the tools if needed
O
O
52
www.scanmaskin.com