10
INSTALLATION
Location
When selecting a position for your Fridge/Freezer you should
make sure the floor is flat and firm, and the room is well
ventilated with an average room temperature of between
10°C and 43°C. Avoid locating your Fridge/Freezer near a
heat source, eg. cooker, boiler or radiator. Also avoid direct
sunlight in out-buildings or sun lounges. If you are placing
your Fridge/Freezer in an out-building such as a garage or
annex ensure that the Fridge/Freezer is placed above the
damp course, otherwise condensation will occur on the
Fridge/Freezer cabinet. Never place the Fridge/Freezer in a
wall recess or into fitted cabinets or furniture. When your
Fridge/Freezer is working, the grille at the back may become
hot and the sides warm. It must therefore be installed so that
the back of the Fridge/Freezer has at least 9cm (31/2”)of
free space and the sides have 2cm (3/4”). Do not drape the
Fridge/Freezer with any covering.
Leveling the Fridge/Freezer
If the Fridge/Freezer is not level, the door and magnetic seal
alignment will be affected and may cause you Fridge/Freezer
to work incorrectly. Once the Fridge/Freezer is placed in its
final location, adjust the leveling feet at the front by turning
them.
Cleaning before use
Wipe the inside of the Fridge/Freezer with a weak solution of
bicarbonate of soda. Then rinse with warm water using a
damp sponge or cloth. Wash the baskets and shelves in warm
soapy water and dry completely before replacing in the
Fridge/Freezer. The external parts of the Fridge/Freezer can
be cleaned with wax polish.
Before plugging in YOU MUST
Check that you have a socket which is compatible with the
plug supplied with the Fridge/Freezer.
Before switching on!
The coolant fluid needs time to settle. If the appliance is
switched off at any time, wait 30 minutes before switching
back on to allow the coolant fluid to settle.
Before filling your Fridge/Freezer
Before storing foods in your Fridge/Freezer, turn the
Fridge/Freezer on and wait for 24 hours, to make sure it is
working properly and to allow the Fridge/Freezer drops to
the correct temperature.
Electrical Connection
~WARNING~
Improper use of the grounded plug can result in the risk of
electrical shock. If the power cord is damaged, have it
replaced by an authorized service center.
This refrigerator should be properly grounded for your safety.
The power cord of this refrigerator is equipped with a three-
prong plug which mates with standard three prong wall
outlets to minimize the possibility of electrical shock.
Do not, under any circumstances, cut or remove the third
ground prong from the power cord supplied.
This refrigerator requires a standard 230 ( or 220~240) V A.C.
~/50Hz electrical outlet with three-prong ground.
This refrigerator is not designed to be used with an inverter.
The cord should be secured behind the refrigerator and not
left exposed or dangling to prevent accidental injury.
Never unplug the refrigerator by pulling the power cord.
Always grip the plug firmly and pull straight out from the
receptacle.
Do not use an extension cord with this appliance. If the power
cord is too short, have a qualified electrician or service
technician install an outlet near the appliance. Use of an
extension cord can negatively affect the performance of the
unit.
START
Display panel is located at the door of the cold storage room,
interface display as follows:
Function Settings
Power up
The first connection of the refrigerator power supply, display
the full light display 2 seconds after the resumption of normal
display, the refrigerator by the smart run by default.
Note: The electric control refrigerator has the function of self
check function, and the function can be ignored when the
refrigerator door is opened for the first time.
Display control
If the cold storage door closed, and no key operation within 3
minutes, the display automatically put out; display off, open
the refrigerator door or press any key, the display light.
Smart
Press the “Function” key to “Smart” icon flashing, press the
“OK” key, enter the intelligent function. At this point, a fridge,
freezer default setting of 5.0
℃
,-18.0
℃
.
