Problem
Caurse
Solutions
Dishwasher will
not start
Fuse blown, or the circuit
breaker tripped
Replace fuse or reset circuit breaker. Remove any other
appliances sharing the same circuit with the dishwasher
Power supply is not turned on
Make sure the dishwasher is turned on and the door is
closed securely.
Make sure the power cord is properly plugged into the wall
socket.
Water pressure is low
Check that the water supply is connected properly and the
water is turned on.
Door of dishwasher not
properly closed .
Make sure to close the door properly and latch it.
The water is not
pumped out
Twisted or trapped drain hose. Check the drain hose.
Filter clogged.
Check the filter system.
Kitchen sink clogged.
Check the kitchen sink to make sure it is draining well. If the
problem is the kitchen sink that is not draining , you may
need a plumber rather than a serviceman for dishwashers.
Foam in the tub
Wrong detergent
Use only the special dishwasher detergent to avoid suds. If
this occurred, open the dishwasher and let suds evaporate.
Add 1 liter of cold water to the tub. Close and latch the
dishwasher, then Start any wash cycle to drain out the
water. Repeat if necessary.
Spilled rinse-aid
Always wipe up rinse-aid spills immediately.
Rust on the cutlery The affected items are not
corrosion resistant.
Avoid washing items that are not corrosion resistant in the
dishwasher.
A programme was not run
after dishwasher salt was
added. Traces of salt have got
into the wash cycle.
Always run the Quick wash programme without any crockery
in the dishwasher and without selecting the Turbo function
(if present), after adding dishwasher salt.
The lid of softer is loose.
Check the softener lid is secure.
Knocking noise
The spray arm is knocking
against an item in a basket.
Interrupt the program, and rearrange the items which are
obstructing the spray arm.
Rattling noise
Item of crockery are loose in
the wash cabinet
Interrupt the program, and rearrange the items of crockery.
Knocking noise in
the water pipes
This may be caused by on- site
installation or the cross-
section of the piping.
This has no influence on dishwasher function. If in doubt,
con- tact a suitably qualified plumber.
The dishes are not
clean
The dishes are not loaded
correctly
See notes in “ Loading the Dishwasher Baskets “.
The programme was not
powerful enough.
Select a more intensive programme.
See” Wash Cycle Table “.
Not enough detergent was
dispensed.
Use more detergent, or change your detergent.
Item are blocking the path of
spray arms.
Rearrange the items so that the spray can rotate freely.
The filter combination in the
base of wash cabinet is not
clean or is not correctly fitted.
This may cause the spray arm
jets to get blocked.
Clean and/or fit the filter combination correctly.
Clean the spray arm jets. See “Cleaning the Spray cabinet is
not clean or Arms”.
