background image

3

PLEASE READ THE OPERATION MANUAL BEFORE USING

TRANSPORTATION AND INSTALLATION:

1.  When you transport the freezer, the angle between the 

compartment body and the ground should be no more than 
45°,and you should never place the freezer up-side down.

2.  Do not use any of the external part as loading points, for 

example, the condenser on the back, the door or the hinge.

3.  When the freezer is installed or used, all the package (in-

cluding board and foam plastic) should be got rid of.

4.  Keeping the freezer stable to avoid vibration and noise.

5.  The freezer should be installed in the place with good venti-

lation, a space of at least 10cm should be allowed between 
the surrounding walls and the cabinet wall for air condition.

6.  It should be placed far from heating resource and not under 

direct sunshine to avoid decrease of the efficiency of refrig-
eration.

7.  Install the freezer in a dry place so as to prevent rust on the 

compartment body, which may affect the electric insulation.

CAUTIONS:

1.  The freezer must be connected with earth correctly, never 

with the heating pipe and coal gas pipe.

2.  In case of any damage on the electric wires and plug, please 

contact the after-sale service and never do it yourself. When 
plug out, please take the plug, not the wires.

3.  If the voltage is unstable, please choose the suitable auto-

matic voltage regulator.

4.  Connection the power to check the freezer before using, the 

freezer can be used until the temperature decreases obvi-
ously after 30 minutes.

5.  You should adjust the temperature control according to the 

requested temperature and quantity of the stored food and 
the environmental temperature.

6.  Before putting the stuff into the freezer please adjust the 

temperature control to the lowest point and let it work till 
the temperature of inner cabinet decreases to -18℃ and then 
putting the stuff in, after 12 hours adjust the temperature 
control to the normal point.

7.  Never put hot food in the freezer directly only after it has 

been cooled naturally outside.

8.  The stuff should be put into the freezer partially, each lot will 

not be more than the figure which is equal to the capacity(L) 
divide by 20.

9.  Not full the freezer and make it crowded, big meat should 

be divided into several small parts. There should be reason-
able space between the foods for better freezing.

10. If power cut off is needed, you should wait for at least 5 

minutes before turn on again to avoid damage to the com-
pressor.

11. The stuff stored should be packed with plastic bag well to 

avoid smell-mixed and moisture-lost, and reduce the frost at 
the small time.

12. 

Never  store  any  flammable,  explosive  and  corrosive 

liquid or gas in the freezer and keep it away from them.

13. 

Beer, beverage, fresh flower, medicine and injections 

can not be put into the freezer.

14. 

Please  make  the  temperature  control  to  the  lowest 

point if you want to store ice cream or other uneasy-frozen food.

DEFROST:

1.  Defrost when the frost thickness on the wall of the cabinet  

reaches 5mm to optimize the freezing capacity. 

2.  Turn the temperature control to the lowest point for 5-6 

hours before defrosting.

3.  Cut off the power and take out the food, use the defrost 

removal, do not apply sharp tools.

4.  After defrosting, clean the wall with dry cloth, and then 

power on.

THE FOLLOWING PHENOMENA ARE NORMAL:

1.  There will be sound of flowing water when the refrigerant is 

running.

2.  The frozen food do not melt even if a long time power off.

3.  When the environment humidity is too high, there will be 

dew condensed on the surface of the freezer.

4.  When the machine is running, the condenser and compres-

sor will be hot.

THE FUNCTION OF CONTROL PANEL:

1.  The figure on the temperature control 1~7 only means the 

temperature level from high to low, not means the specific 
temperature, turn the knob clockwise, the temperature 
inside will go down, turn the knob to the other direction, the 
temperature will go up.

2.  The red light is working light, the light-on means the com-

pressor is working. 

TECHNICAL DATA:

MODEL   . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .155

ANTIELEC TRICITY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . I

CAPACITY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .136 ltr

INPUT POWER  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .190

POWER CONSUMPTION (kW·h/24h). . . . . . . . . . . . . . . . . 2.05 kw

NET WEIGHT, (kg). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .47

OVERALL DIMENSION  (mm)  . . . . . . . . . . . . . . . . .564×712×1189

Reviews: