16
Hints and Tips
The cooktop cannot be turned on.
• No power.
• Make sure the ceramic hob is connected to the power supply
and that it is switched on.
• Check whether there is a power outage in your home or
area. If you’ve checked everything and the problem persists,
call a qualified technician.
The touch controls are unresponsive.
• The controls are locked.
• Unlock the controls. See section ‘Using your ceramic cooktop’
for instructions.
The touch controls are difficult to operate.
• There may be a slight film of water over the controls or you
may be using the tip of your finger when touching the con-
trols. Make sure the touch control area is dry and use the
ball of your finger when touching the controls.
The glass is being scratched.
• Rough-edged cookware.
• Unsuitable, abrasive scourer or cleaning products being used.
Use cookware with flat and smooth bases. See ‘Choosing the
right cookware’.
• See ‘Care and cleaning’.
Some pans make crackling or clicking noises.
• This may be caused by the construction of your cookware
(layers of different metals vibrating differently). This is
normal for cookware and does not indicate a fault.
Installation
Selection of installation equipment
Cut out the work surface according to the sizes shown in the
drawing. For the purpose of installation and use, a minimum of
50mm space shall be preserved around the hole.
Be sure the thickness of the work surface is at least 30mm.
Please select heat-resistant work surface material to avoid larger
deformation caused by the heat radiation from the hotplate.
A 268±4 mm
B 500±4 mm
C 50mm mini
D 50mm mini
E 50mm mini
F 50mm mini
The ceramic cooker hob can be used on the table top of cabinet.
The ceramic hob should be placed horizontally.
Under any circumstances, make sure the ceramic cooker hob is
well ventilated and the air inlet and outlet are not blocked. En-
sure the ceramic cooker hob is in good work state. As shown
below
Note: The safety distance between the hotplate and the cup-
board above the hotplate should be at least 760mm.
A 760 mm
B 50 mm min.
C 30 mm min.
D Air intake
E Air exit 10 mm
Before locating the fixing brackets
The unit should be placed on a stable, smooth surface (use the
packaging). Do not apply force onto the controls protruding from
the hob.
Fix the hob on the work surface by screw four brackets on the
bottom of hob (see picture) after installation. Adjust the bracket
position to suit for different work surface’s thickness.
Cautions
1 The ceramic cooker hob must be installed by qualified per-
sonnel or technicians. We have professionals at your service.
Please never conduct the operation by yourself.
2 The ceramic cooker hob shall not be mounted to cooling
equipment, dishwashers and rotary dryers.
3 The ceramic cooker hob shall be installed such that better
heat radiation can be ensured to enhance its reliability.