1
2
4. Set Shoe against edge of rim.
Note: To adjust Shoe, remove R-Clip and Pin,
move Shoe, then replace Pin and R-Clip.
5. Push down on Mount/Demount Bar, forcing
bead off the rim. Repeat in several locations if
necessary.
6. After bead is broken, turn tyre over and break
bead on other side. (See Figure D.)
COMPONENTS
:
REMOVING TOP BEAD:
1. Loosen Knob on Support Arm, pull Center Post up enough for tyre to clear, then tighten Knob.
2. Place tyre on Changer, making sure edges of Wheel Clamps are positioned between tyre and
rim.
(See Figure F.)
Note
: If tyre has rotor, place it on Changer rotor side up.
3. Turn Handle to tighten Adjustable Wheel Clamp until rim is firmly secure and will not move,
then tighten bolts on Adjustable Wheel Clamp.
4. Lower and secure Center Post.
4. Mount Motorcycle Tyre Changer Adaptor
Base over Portable Tyre Changer Center Post.
Secure by tightening Knob.
5. Slide Wheel Clamps (4) onto Support Tubes
and secure with Bolts (6),Flat washers
Ø10(7),and Nuts (13). (See Figure B.)
6. Attach Vertical Support Bar (3) to Adjustable
Support Tube and secure with Bolts (14),Flat
washers Ø10(7),Lock washers Ø10(16) and
Nuts (13).
7. Attach Support Arm (2) to Vertical Support
Bar and secure with Bolts (14),Flat washers
Ø10(7),Lock washers Ø10(16) and Nuts (13).
8. Slide Center Post (1) down Support Arm tube
and into Base. Thread Knob (10) into Support
Arm.
9. Secure Center Post by tightening Knob. (See Figure c.)
DEMOUNTING TYRE:
BEAD BREAKING:
Note: Before removing tyre, mark rotation
direction on rim to ensure correct replacement.
Note: Use tyre lubricant (not included) as
needed.
1. Remove valve cap. Deflate tyre by removing
valve core with valve core remover (not
included).
For Tubed Tyres:
Remove valve nut.
CAUTION!
Tyre is under extreme pressure.
Maintain firm grip on core and remover to
prevent pressure from propelling them and
causing injury.
2. Lubricate area where sidewall meets rim.
Note: Use blocks and rim protectors (not
included) to protect rim and/or rotor from
damage.
3. Insert flat end of Mount/Demount Bar (from Portable Tyre Changer) into Bead Breaker
Handle.
Figure F
Edge of
Wheel clamp
Summary of Contents for 394021
Page 1: ......
