Filling of Liquids
First unscrew the atomizer base off the GS Air 2. Then
slowly fill the e-liquid into the GS Air 2 clearomizer
along the tube on the side. Finally screw the atomizer
base back onto the GS Air 2 clearomizer. Please do not
overfill and do not fill e-liquid into the vent pipe in the
middle of the device.
Please refill the device with liquid when the liquid level
is less than 10%.
Changing the Atomizer Head
Separate the atomizer base from the tank of the GS Air 2 clearomizer. The atomizer
head is located on the base. Just unscrew and replace it. Finally, connect the com-
ponents together again. Make sure that the clearomizer is firmly closed.
Adjusting the Air Supply
The airflow control is located on the atomizer base. By adjusting the screw it is
easily adaptable to your vapor preferences. The more the slot is open, the lower
is the drawing resistance. Pay particular attention to a sufficient air supply during
sub-ohm vaping.
Changing the Mouthpiece
The mouthpiece is inserted into the top of the clearomizer. Accordingly, it can
be removed by gently pulling up and once again attached by applying gentle
pressure on clearomizer. The mouthpiece may be cleaned with warm water. Make
sure the mouthpiece is completely dry before reinserting into the clearomizer.
Main Features & Performance
SC GS Air 2 Clearomizer
Tank volume
Length
Diameter
Thread type
Suitable Atomizer Heads
The GS Air 2 clearomizer is suitable for SC GS Air Pure Cotton Heads with a
resistance of 0.75 ohm and 1.2 ohm.
2.0 ml
7.0 cm
1.4 cm
510
Warranty & Service
If the product ceases functioning or is defective in any way, please contact the
specialist retailer where you purchased the product. If you have any questions about
the product‘s operation or its use, please do not hesitate to contact our customer
service department.
Please do not use accessories from other manufacturers in combination with your GS
Air 2 atomizer. If this does result in damage, it is not covered by the SC warranty and
your warranty will be void.
Commissioning
Prior to first use, drip a few drops of your liquid on the atomizer coil and let it sit before
vaping. Please take several puffs without activating the atomizer and leave the atomi-
zer sit for 15 minutes in the e-liquid filled tank before use. Don’t clean atomizer heads
with water. Because atomizer coils are wearing parts, they must be changed regularly.
Assemble the individual components of the product as described below. Use a dry
cloth or cotton swab to clean the device.
Use a dry cloth or cotton swab to clean the device.
Width of the liquid tank’s filling holes
*
*
Contents
•
1x GS Air 2 Clearomizer
•
1x GS Air Pure Cotton Head 0.75 Ohm
•
1x Mouthpiece
•
1x User Manual
Manufactured for SC –
Innocigs GmbH & Co. KG,
Stahltwiete 23 | 22761 Hamburg | GERMANY
E-mail: [email protected]
Phone: +49 (0) 40 609 4671 8
Web: www.innocigs.com
Made in China
mouthpiece
Atomizer Head
Atomizer Tube
Atomizer Base
