Document
9911004rev27
Title
Date
2017-02-16
Page
78(81)
SBS MicroSMART Battery Charger Technical Handbook
•
Bit9: Derate Iset because charger can’t
deliver output
•
Bit10: Derate Pset because charger can’t
deliver output
•
Bit11: Overvoltage
•
Bit12: Overcurrent
•
Bit13: Overpower
•
Bit14: Charger can’t deliver rated output
•
Bit15: Charger can’t deliver output
Board temperature
Charger control board internal temperature.
Heat sink temperature
Charger heat sink temperature.
Battery ID
Identifier of the battery connected to the
charger. Only relevant if
Charging mode
set to
BMU.
11.5.
Momentary log
The momentary log is not stored in the charger but can be read out momentarily by the SBS
MicroSMART Service tool.
DC Voltage (V)
Actual battery charging voltage. If a
Cable Ri
is
defined this voltage will be (measured charging
voltage –
Cable Ri
*measured battery charging
current).
DC Current (A)
Actual battery charging current. If a
Base load
is
configured this charging current will be measured
charging current –
Base load
.
Board temperature
Charger control board internal temperature.
Heat sink temperature
Charger heat sink temperature.
