
4
3.
START-UP :
Manual operation
Open the main gas valve.
Switch the power on.
Start the heater ignition cycle.
If the flame is not lit after 30 seconds, the heater goes to safety state.
The sequence of ignition can begin again only after switching the power off.
After 5 seconds, switch the power on.
The heater is on as long as : power supply is on and the valves
are opened.
If the flame is still not lit or goes out, close the main gas valve, switch
the power off and call your SBM installer.
Automatic control
(VisioLon Ind-I control module)
Open the main gas valve.
Switch the power on.
Check the settings (temperature, time).
Change module programming if necessary.
The module automatically controls the ignition and the extinction of the
heaters.
The sequence of ignition is identical to the manual operation describes
above.
4. SHUT OFF :
Close the main gas valve.
Switch the power off.
5. MAINTENANCE :
To be performed
once a year
by your SBM installer, according to the
SBM INSTALLER INSTRUCTIONS Nr. 05000310.
6. CHANGING THE GAS USED :
For any change in the type of gas used, please contact your SBM
installer.