Important: Read all instructions prior to installation.
RGB LED Controller with Wireless RF Remote
User Manual
Part Number:
4400 Earth City Expy, St. Louis MO 63045
866-590-3533 [email protected]
MCBRF-RGBW
12. Waterproof
The MCBRF-RGBW LED controller is fully waterproof with IP68 standard, and can
be used under water within a depth of 30 meters.
Note: The remote receiving sensitivity will decrease when controller is installed in a
wet environment.
13. Protection
This controller has full protection function for output short circuit, overload, and
overheat. The controller will automatically recover from protection when working
status is good.
Please ensure the LED loads are in rated range, outputs are not shorted and the
controller unit is in a good heat dissipation environment.
Advanced Features
FCC Statement
Operation
11. Using Remote
Please remove the battery insulator before using. The remote uses a 3V CR2025
battery. The RF wireless remote signal can pass through most materials. For proper
receiving of the remote signal, please do not install the controller in metal enclosures.
11. Pairing New Remote
The remote and the controller is 1 to 1 paired as default. Further more, one master
unit can be paired to 5 remote controllers and every remote can be paired to any
master unit.
Please do the following steps to pair the new remote to the controller.
1) Turn off the power of the main unit and turn back on after 5 seconds.
2) Press remote 'ON' and 'White ' key together in 5 seconds after power is
restored , and then press 'RED' key in for another 5 seconds.
After this operation, the main unit indicator will flash white for 3 times to display the
command is accepted, the main unit now recognizes the new remote. Only 5 latest
paired remote controllers can be recognized by the controller.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired
operation. Any changes or modifications in construction
of this device which are not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.