SBL MCBRF-RGBW User Manual Download Page 1

Important: Read all instructions prior to installation.

User Manual

Part Number:

4400 Earth City Expy, St. Louis MO 63045 

866-590-3533                [email protected]

Parts Included

Installing

MCBRF-RGBW

1. Turn On/Standby

Press 'I' key to turn on unit or press 'O' key to turn off. At power on, unit will 
automatically turn on and restore the previous settings.

2. White Mode

These two keys control white LED working mode. Press 'WHITE ONLY' key, 
all RGB colors will turn off and only white LED lights up. Press 'WHITE OFF' 
key, the white LED will turn off and RGB LED remains on it's previous status.

3. White Brightness

Adjust white LED brightness. Press the right side key to increase white LED 
brightness and the left side key to decrease white LED brightness.

4. Static RGB Color Selection

These keys control the RGB static color.
a) Pressing the color printed keys will set the RGB LEDs to correspond color 
light as the key. There are 6 shortcut color keys to make direct color selection.
b) Press 'COLOR+' and 'COLOR-' to scroll over all preset static colors, 
including the 6 shortcut key colors.

5. Color Brightness

Adjust RGB color brightness. Press the right side key to increase RGB LED 
brightness and the left side key to decrease RGB LED brightness.

6. RGB Dynamic Modes Control

These keys control the RGB dynamic modes.
a) Press 'MODE+' and 'MODE-' key to select preset dynamic modes.
b) Press 'SPEED+' and 'SPEED-' to control the dynamic mode running speed.

7. Remote Controller Indicator

The blue indicator will blink when remote control is transmitting a command. 
The remote controller works at radio frequency. The remote controller's use is 
not restricted by normal obstructions such as walls, doors, etc.

1 - LED Controller

1 - Wireless Remote

1 - CR2025 3V Battery

Functions

Specifications

Dynamic Mode

34 modes

Static Color

30 colors

PWM Grade

256 Steps

White Brightness Grade

10 levels

Color Brightness Grade

5 levels

Speed Grade

10 levels

Direct Color Select

6 direct keys

Overload protection

Yes

Overheat protection

Yes

Working Voltage

DC 6-24V

Battery

3V CR2025

Remote frequency

433.92MHz

Remote control distance

>15m at open area

Rate Output Current

3x2.5A + 4A

IP Rating

IP68

FCC ID

2ACJPRM06

8. Power Supply Wiring

The red power cable should be connected to power positive and black to negative. 
The controller unit can work from DC 6V to 24V, Please make sure the power supply 
voltage is same as the LED load and the power supply is adequite for the circuit.

9. LED Ouput Wiring

This controller supports constant voltage driving LED products with a 

common anode connection. The black cable on the ouput side is the 

common anode, it connects to the power supply positive inside the 

controller. The white, green, red and blue cable runs the driving signal 

of relevant LED color, please connect the color cable to the cathode of 

relevant color LED loads and the black cable to the common anode.

10. Status Indicator

The is a full color status indicator. It displays all working statuses of the controller. It 
indicates different events as following:

Blue:

 normal working.

Short single white flash: 

new command executed.

Long single white flash: 

reach mode or color cycle edge.

Long single yellow flash:

 

reach speed or brightness limit.

Red flash:

 

overload protected.

Yellow flash:

 

overheat protected.

RGBW LED Controller with Wireless RF Remote

Reviews: