SBIG
S
ANTA
B
ARBARA
I
NSTRUMENT
G
ROUP
SBIG CFW-9
Page 5
A permanent mounting of the
CFW-9
to the ST-
7/8/9/10/2000 cameras is accomplished by attaching the CFW-9
directly to the face plate of the camera by the following procedure:
1. Remove the ST-7/8/9/10/2000's "D-block" and T-Thread ring
held in place with 4 phillips head screws and set the screws aside.
[The T-Thread mount is where the nose piece screws into the camera
head. It is a block approximately ¼” thick and shaped like the letter
“D” attached to the face plate of the camera. It has three set screws
holding an internal ring that has female T-Threads].
2. Remove the cover of the
CFW-9
and pull the filter magazine
out of the housing.
3. Remove the four rubber hole plugs from the rear of the
CFW-
9
by pushing them through the housing with a small allen tool. Save
