2
/4
Installation Guide | 26-605_ENG01 03-2016
www.sbc-support.com
Saia-Burgess Controls AG
Q.RCU-A-xxxx Series
General Installation Requirements
Turn off power before any kind of servicing.
-
All wiring must comply with electrical wiring diagrams as
well as national and local electrical codes.
-
To connect the wiring to the device, use the terminal con-
nectors which are located inside the device’s enclosure. Use
a small flat screwdriver to tighten the terminal connector
screws once the wires have been inserted.
-
The board connectors accept wires or flat cables rang
-
ing from
-
0.64…1.63 mm diameter per pole.
-
It is recommended that all terminals be wired by 18 AWG
wire except for network communications.
Device Components
Figure 1:
Mounting a Smart-Sensor
Device Dimensions
Figure 2:
From mid left to right: Front view, side view, back plate
