J11
English
Saia-Burgess Controls AG, Bahnhofstrasse 18, CH-3280 Murten, Switzerland
www.saia-pcd.com
431950610A
08.2016
Subject to change without notice
Mounting instructions for
PCD7.RD4-SD
on PCD7.D457xxxx HW version C or newer
ATTENTION: ELECTROSTATIC DISCHARGE SENSITIVE DEVICES
1. Remove the backcover
by removing the 2 screws shown below.
2. Place the 2 support screws, turning them
by hand until they are started into their holes.
3.. Use 5.5 mm socket/wrench to screw in the
screws. Keep them perpendicular to the PCB
as much as possible.
Do not over tighten.
Stop when the screw touches the PCB.
4. Plug the red connector on the bottom of the
module into J11 of the PCB. The module will
then be resting on the 2 support screws.
5. Screw the module to the screw supports.
6. Module is installed. Remove black rivet to
install SD Card, then replace it.
Replace backcover.
