Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and satisfactory
operation of this product. Please retain these instructions for future reference.
Warning
Layout
• Plan the desired layout of this fitting carefully, ensuring the cables will reach the distance between the junction box and
the light fitting.
• Avoid locating any cables in positions that would cause a hazard. Position cables and junction boxes (not supplied)
away from areas where they may be at risk from being cut, trapped or damaged.
• The mains supply cable must have a minimum cross sectional area of 1.0mm².
• Cables must be protected using suitable conduit or plastic trunking.
• The products can be wall or ceiling mounted. If wall mounting ensure that the power supply is at the bottom.
Existing fittings must be completely removed before
installation of a new product. Before removing the existing
fitting,
carefully note the position of each set of wires.
• Gently pull the casing away from the shade and set
aside.
• Remove the 4 fixing screws and detach the shade. Keep
safe for refitting later.
• Hold the product in place and mark the position of the
holes. Ensure the wall is capable of holding the weight
of the product, or if fitting to a ceiling, ensure there is
a joist at the point of fixing to support the weight of the
product.
• Knock out the chosen fixing holes
• Fix into position. Take care to avoid damaging any
concealed wiring and pipes. The correct fixings should
be used for brick, cavity walls or plasterboard.
• Pierce a hole in the grommet, and pull the cable
through.
• Wire as detailed below
Installation
This product is Class 2 (Double insulated)
and must not be earthed.
Please read these instructions carefully before
commencing any work.
This unit must be fitted by a competent and qualified
electrician.
Install in accordance with IEE Wiring regulations and
current Building Regulations.
To prevent electrocution switch off at mains supply
before installing or maintaining this fitting. Ensure
other persons cannot restore the electrical supply
without your knowledge. If you are in any doubt,
please consult a qualified electrician.
This light fitting should be connected to a circuit with a
30mA RCD fitted.
If replacing an existing fitting, make a careful note of
the connections.
This product contains non-replaceable parts and
cannot be serviced. If damage occurs the part should
be scrapped.
Waste electrical products should not be disposed of
with household waste. Please recycle where facilities
exist. Check with your local authority or retailer for
recycling advice.
This product is rated at IP65.
Specification
Voltage:
240V ~ 50Hz
Lamp:
17W LED Module - 4200K
IP rating:
65
• Ensure that the screws and cable entry points are sealed
to maintain the IP rating of the product.
• Refit the shade, ensuring that the seals are correctly
located.
• Gently push the casing onto the shade until it clips in
place.
• Replace fuse or circuit breaker and switch on. Your light
is now ready for use.
Commissioning
Wiring
Check that...
• This product is double insulated and must not be earthed. If there are any incoming earth cables, they must be terminated
in the spare terminal of the connection block. Having correctly identified the wiring from your existing light fitting,connect
to the quick fit connection block in the following way:
• You have correctly identified the wires.
• The connections are tight.
• No loose strands have been left out of the connection block.
INSERT CABLE
PUSH DOWN
EARTH (TO TERMINATE)
