Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and satisfactory
operation of this product. Please retain these instructions for future reference.
Warning
This light fitting is Class 1 and must be connected to
an Earth circuit
Please read these instructions carefully before
commencing any work.
It is recommended that these floor standing lights
are installed by a qualified electrician in accordance
with current IEE Wiring Regulations and local Building
Regulations and are for the Domestic environment only.
To prevent electrocution switch off at mains supply
before installing or maintaining this fitting. Ensure other
persons cannot restore the electrical supply without
your knowledge. If you are in any doubt, please consult a
qualified electrician.
This light fitting should be connected to a circuit with a
30mA RCD fitted.
If replacing an existing fitting, make a careful note of the
connections.
This system contains non-replaceable parts and cannot be
serviced. If damage occurs the part should be scrapped.
Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist.
Check with your local authority or retailer for recycling
advice.
These lights have an IP54 (splash proof) rating suitable
for use outdoors.
This product is not suitable for dimming.
This product is not suitable for location in or near a
marine or sea environment.
Specification
Voltage:
240V 50Hz a.c.
Lamp:
9W LED (SMD 5630)
IP rating:
54
Layout
• Plan the desired layout of this fitting carefully, ensuring
the cables will reach the distance between the junction
box and the light fitting
• Avoid locating any cables in positions that would
cause a hazard. Position cables and junction boxes (not
supplied) away from areas where they may be at risk
from being cut, trapped or damaged
• Cables in walls must be protected using suitable
conduit or plastic trunking.
• We recommend that you use H05RN-F specification
cable (not supplied) which is an outdoor grade, rubber
sheathed cable. The mains supply cable must have a
minimum cross sectional area of 1.0mm²
• These fitting must be mounted on either a concrete
surface or a paving slab that has been concreted in
position.
Installation
Existing fittings must be completely removed before
installation of a new product. Before removing the existing
fitting,
carefully note the position of each set of wires.
• Using the base plate as a template, mark the fixing
holes onto the mounting surface.
• Drill holes to the necessary size and depth - taking care
not to damage any concealed pipes or wiring below the
mounting surface.
• This product comes complete with screw and rawl plugs
which are suitable for use on most surfaces, however
alternative fixings may be required.
• Push the rawl plugs into the mounting holes.
• Fit base plate to mounting surface using supplied
screws
Wiring
Having correctly identified the wiring from your existing
light fitting, pull the wire through the hole and connect to
the connection block inside the product in the following
way:
• Pull terminal block from inside of tube.
• Unscrew the 4 screws which attach the black box to
the spacing strip. Open the black box and pull out the
terminal block.
• Connect Live input wire to brown wire on product (or
terminal on terminal block marked ‘L’).
• Connect Neutral input wire to blue wire on product (or
terminal on terminal block marked ‘N’).
• Connect Input Earth wire (Green/yellow) to Earth wire on
fitting,
• Check that you have correctly identified the supply
wires, the connections are tight and that no loose
strands have been left out of the connection block.
• Push terminal block back into the black box. Re-attach
the black box to the mounting bracket.
