Instruction leaflet
Tribeca Post and Bollard
EL- 40075, EL- 40076
www.saxbylighting.com
For your safety, always switch off the supply before changing lightbulbs, or cleaning.
If any part of the (LED) housing is broken or cracked then it cannot be replaced and the fittings must not be used - as the
water ingress protection has been compromised.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.
Recycling advice
Safety information
Saxby Lighting Ltd. LS9 0SE
We recommend cleaning with a soft dry cloth.
Do not use solvents or abrasive cleaners as these could
damage the finish.
Iss.2 20150717
• The LED's in this product are non replaceable.
Fitting/replacing bulbs
Commissioning
• Push the terminal block up into the tube.
• Stand the product in place inline over the mounting holes
and use a suitably sized screwdriver to tighten the screws
so that they hold the fitting securely to the mounting
surface.
• Replace fuse or circuit breaker and switch on. Your light
is now ready for use.
