Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and
satisfactory operation of this product. Please retain these instructions for future reference.
Warning
This is a Class 1 product and must be earthed
Please read these instructions carefully before
commencing any work.
This unit must be fitted by a competent and qualified
electrician.
Install in accordance with IEE Wiring regulations and
current Building Regulations.
To prevent electrocution switch off at mains supply
before installing or maintaining this fitting. Ensure
other persons cannot restore the electrical supply
without your knowledge.
This light fitting should be connected to a fused circuit.
If replacing an existing fitting, make a careful note of
the connections.
This system contains non-replaceable parts and
cannot be serviced. If damage occurs the part should
be scrapped.
This product is not suitable for dimming.
This product is rated at IP44.
This product contains a demister pad. If this pad is
damaged in anyway then it should be replaced by a
qualified electrician.
Waste electrical products should not be disposed of
with household waste. Please recycle where facilities
exist. Check with your local authority or retailer for
recycling advice.
Specification
Voltage:
240V 50Hz a.c.
Lamp:
2 x 1.5W LED (Capsule) Cool white & 5.5W LED (SMD 2835) Cool White
IP rating:
44
Shaver socket: 115V - 240V dual socket
Layout
• Cables in walls must be protected using suitable
conduit or plastic trunking.
• The mains supply cable must have a minimum cross
sectional area of 1.0mm².
• This product has special protection against the
ingress of moisture and is IP44 rated.
• This product is fitted with a no touch infra-
red switch, helping to keep the mirror clear of
fingerprints. When installing the product, the sensor
switch must be at least 150mm from an adjacent
wall or obstruction to ensure the switch can function
properly.
Existing fittings must be completely removed before
installation of a new product. Before removing the
existing fitting, carefully note the position of each set
of wires.
• Undo the screws (two on each side of the fitting)
and remove the front mirror assembly and set aside.
• Hold the back plate in place and mark the position of
the fixing holes. Ensure that the product is level.
• Ensure the wall is capable of holding the weight of the
product. Take care to avoid damaging any concealed
wiring and pipes. The correct fixings should be used
for brick, cavity walls or plasterboard.
• Pierce grommet and pass the supply cable through
the hole in the wall back.
• Fix the product into position.
Installation
Having correctly identified the wiring from your existing
light fitting, connect to the connection block inside the
product in the following way:
Wiring
Check that...
• You have correctly identified the wires
• The connections are tight
• No loose strands have been left out of the connection
block.
This product is suitable for use in Zone
2 and outside Zones of a bathroom.
See diagram. If this unit is being
fitted in a room containing a bath or
shower, a 30mA RCD must be used,
in accordance with IEE regulations.
