• Push the labelled male and female connectors
together to power the demister pad.
• Refit the mirror front onto the wall back. Ensure that
the seals are correctly located before securing with
the four screws.
• Replace fuse or circuit breaker and switch on. Your
light is now ready for use.
• Activate your new LED mirror by swiping your hand in
front of the sensor.
Commissioning
Instruction leaflet
Rift Mirror
60895
www.saxbylighting.com
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
Recycling advice
Safety information
Saxby Lighting BH23 3PE
• We recommend cleaning with a soft dry cloth. Do
not use solvents or abrasive cleaners as these could
damage the finish.
• Mirror – Use a damp cloth or a propriety glass
cleaner. Do not use abrasive materials as these will
damage the finish.
Live Voltages may be present in this unit even when turned of or when completely disconnected. For your safety,
always switch off the supply before changing lightbulbs, or cleaning.
The mirror must be replaced immediately should it become cracked or damaged. This fitting must
not be used without the mirror in place.
• The shaver socket is powered by a 20W isolating
transformer and is only intended for use with electric
shavers, electric toothbrush chargers and similar
products.
• Any appliance connected to the socket must not
exceed the 20W power output as this could cause
damage and overheating to occur.
• Always check your appliance instructions to ensure
the power requirements are less than 20W.
• Simply turn on the demister switch on the side. The
demister pad will warm the mirror surface.
• The demisting effect will spread approximately 10 -
20% further than the pad itself.
Shaver Socket Instructions
Demister Operation
Iss.1 08072015
