Thank you for purchasing this light fitting.
Please read the instructions carefully before use to ensure safe and satisfactory operation of this product.
Please retain these instructions for future reference.
You have correctly identified the wires.
The connections are tight.
No loose strands have been left out of the connection block.
Warning
Specification
Installation
Wiring
Layout
Check That
Commissioning
•
Plan the desired layout of this fitting carefully, ensuring the cables will reach the distance between the junction
box and the light fitting.
•
Avoid locating any cables in positions that would cause a hazard. Position cables and outdoor rated junction
boxes (not supplied) away from areas where they may be at risk from being cut, trapped or damaged.
•
We recommend that you use H05RN-F specification cable (not supplied) which is an outdoor grade, rubber
sheathed cable. The mains supply cable must have a minimum cross sectional area of 1.0mm²
•
Cables must be protected using suitable conduit or plastic trunking.
Having correctly identified the wiring from your existing light fitting, pull the wire through the hole and connect to
the connection block inside the product in the following way:
Voltage:
240V 50Hz a.c.
Lamp:
35W GU10 Halogen
IP rating:
65
4.
Wrap the terminal block in tape, covering 2cm on each side of the connections.
5.
Push terminal block back onto the retaining pegs inside mounting box.
6.
Fit the product back on to the mounting box and refit grub screws, tighten grub screws to secure.
7.
Replace fuse or circuit breaker and switch on. Your light is now ready for use.
1. Existing fittings must be completely removed
before installation of a new product. Before
removing the existing fitting, carefully note
the position of each set of wires.
2.
Remove mounting box (A) from product
by removing grub screws (C). Pull terminal
block off of retaining pegs in mounting box.
Carefully pierce a small hole in the rubber
gasket in the centre of the mounting box to
allow the cable to pass through.
3.
Thread the cable through the hole and fix the
mounting box to the wall using the screws
and plugs supplied (B). Take care not to
damage any concealed wiring.
A
B
C
175.0mm
63.0mm Dia
92.0mm
This is a Class 1 product and must be earthed.
Please read these instructions carefully before commencing any work.
This unit must be fitted by a competent and qualified electrician.
Install in accordance with IEE Wiring regulations and current Building Regulations.
To prevent electrocution switch off at mains supply before installing or maintaining this fitting. Ensure other persons
cannot restore the electrical supply without your knowledge. If you are in any doubt, please consult a qualified
electrician.
This light fitting should be connected to a circuit with a 30mA RCD fitted.
If replacing an existing fitting, make a careful note of the connections.
Always use the correct type and wattage bulb. Never exceed the wattage stated.
When changing a bulb, always switch off at the mains and allow the old bulb to cool down before handling.
Dispose of used bulbs carefully and responsibly.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your local authority or retailer for recycling advice.
This product is rated at IP65.
This product is not suitable for location in or near a marine or sea environment.
The entire unit gets hot whilst on for a period of time.
