• When changing a bulb, always switch off at the
mains and allow the bulb to cool before handling.
Used bulbs should not be disposed of with household
waste. Please recycle where facilities exist.
• Always use the correct type and wattage bulb. Using
the incorrect wattage bulb will damage the bulb and
ballast.
Commissioning
Fitting/replacing bulbs
Instruction leaflet
Lille Wall
43699 & 43753
www.saxbylighting.com
For your safety, always switch off the supply before changing lightbulbs, or cleaning.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
Recycling advice
Safety information
Saxby Lighting Ltd. BH23 3PE
We recommend cleaning with a soft dry cloth.
Do not use solvents or abrasive cleaners as these could
damage the finish.
Glass parts – Remove and wash in warm water or just
use a damp cloth. Do not use abrasive materials as
these will damage the finish.
This bulb is protected by a plastic shade. This part must be replaced immediately should the plastic
shade become cracked or damaged. This fitting must not be used without the plastic shade in place.
Replace Cracked
Shade
• Ensure that there are no bare or loose strands of
wire exposed, and cover all exposed areas of the
connection block with two layers of insulation tape.
• Refit the plastic shade, and secure using the side
screws (B).
• Refit the cover, and secure using screw (A).
• Replace fuse or circuit breaker and switch on. Your
light is now ready for use.
Iss.2 30052014
18W G24d-2 2 PIN PLC
