Instruction leaflet
Icarus Twin Wall
EL-40054
www.saxbylighting.com
Saxby Lighting Ltd. LS9 0SE
Iss.3 10022017
Commissioning
For your safety, always switch off the supply before changing lightbulbs, or cleaning.
This system contains non-replaceable parts and cannot be serviced. If damage occurs the part should be scrapped.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.
Recycling advice
Safety information
We recommend cleaning with a soft dry cloth.
Do not use solvents or abrasive cleaners as these could
damage the finish.
This light source is protected by a shade. This part must be replaced immediately should the shade
become cracked or damaged. This fitting must not be used without the shade in place.
Replace Cracked Shade
•
Diagram C.
Place the fitting over the back plate,
ensuring that the bolts in the back plate are aligned with
the holes in the front of the fitting. Replace the domed
nuts (3) to secure the fitting. Do not over tighten.
• Fit bulbs as detailed below.
• Replace the bulb covers (4).
• Replace fuse or circuit breaker and switch on. Your light
is now ready for use.
Diagram C.
(3)
(4)
• When changing a bulb, always switch off at the mains
and allow the bulb to cool before handling.
• Always use the correct type and wattage bulb. Using the
incorrect wattage bulb will damage the bulb and ballast.
• Used bulbs should not be disposed of with household
waste. Please recycle where facilities exist.
• Gently pull the bulb out from the lampholder to remove.
Gently push new bulb into lampholder to replace.
Fitting/replacing bulbs: Max. 2.5W GU10 COB
