satisfactory operation of this product. Please retain these instructions for future reference.
Warning
The power supply is Double Insulated and does not
require connection to an Earth circuit.
The LED strips are Safety Extra Low Voltage and
must not be earthed.
Please read these instructions carefully before
commencing any work.
electrician.
Install in accordance with IEE Wiring regulations and
current Building Regulations.
when installing or maintaining this system.
cannot be serviced. If damage occurs the part should
be scrapped.
Waste electrical products should not be disposed of
with household waste. Please recycle where facilities
exist. Check with your local authority or retailer for
recycling advice.
Battery care:
Always remove exhausted batteries from the remote
control. Always insert the battery with the correct
product is suitable for use by adults only.
Specification
Layout
which can be stuck to most surfaces.
of 100mm or multiples of 100mm.
ensuring the cables will reach the distance between
away from areas where they may be at risk from
being cut, trapped or damaged.
conduit or plastic trunking.
very wet areas.
Basic Installation
Specification
5000mm
this stage.
ensure that the cable can connect when in the
desired position.
the line on the strip with four copper pads, as shown
below.
anywhere else on the strip as this may cause the
Seal the end with a small amount of silicone sealant.
correct.
