Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and
satisfactory operation of this product. Please retain these instructions for future reference.
Warning
The power supply is Double Insulated and does not
require connection to an Earth circuit.
The LED units are Safety Extra Low Voltage and
must not be earthed.
Please read these instructions carefully before
commencing any work.
This unit must be fitted by a competent and qualified
electrician.
Install in accordance with IEE Wiring regulations and
current Building Regulations.
This system operates at Safety Extra Low Voltage via a
transformer. Never connect the light fittings directly to
the mains without using a transformer.
Ensure that the supplied transformer is used.
The mains plug must be situated indoors (e.g. house,
garage, shed) in order to protect it from the elements.
Do not exceed the transformer load. Transformers may
require a minimum load to operate.
Always disconnect the transformer from the mains
when installing or maintaining this system.
This system contains non-replaceable parts and
cannot be serviced. If damage occurs the part should
be scrapped.
This product cannot be dimmed.
Waste electrical products and batteries should not
be disposed of with household waste. Please recycle
where facilities exist. Check with your local authority
or retailer for recycling advice.
Specification
The Kit should contain:
• BS plug and in-line transformer with 8.2m cable
• 4x LED Lights with 3m cable
• 4 way connector box
Layout
• Plan the desired layout of these fittings carefully,
ensuring the cables will reach the distances between
the transformer and each light fitting.
• Avoid locating any cables in positions that would
cause a trip hazard. Position cables away from areas
where they may be at risk from being cut, trapped or
damaged.
• Ensure the connectors are accessible for future
maintenance.
• The mains plug has no special protection against
moisture and must be situated indoors.
• The light units are rated at IP44. Avoid positioning
head units and connectors in very wet areas.
• All 4 heads must be connected to the connector box
to ensure a complete loop connection so that the
lights remain switched on.
•
Only use this product in conjunction with the
In-line Transformer and Connector Box supplied.
Do not attempt to modify any component supplied.
• Firstly layout all the LED Lights units and cable in
their desired location to ensure the Supply Cable
from each unit will reach the Connector Box.
The Connector Box may need to be relocated to
accommodate the Light Unit positions. DO NOT
DRILL ANY SURFACE UNTIL YOU ARE CONFIDENT
ALL CABLE WILL CONNECT.
• The Diagram below shows the basic layout of the
kit, again ensure cable do not present a hazard
whilst determining installation.
• Drill a 30mm hole in the fixing surface, pass the
supply cable through and insert the Deck Light unit.
Bring the cable to the Connector Box and insert
firmly. Repeat this with the remaining units.
• The Connector Box should be firmly fixed to a
surface above ground level.
• Connect the Connector Box supply cable into the
in-line Transformer, plug into the mains and switch
on to test.
Installation
3m
3m
3m
3m
3m
0.2m
5m
30mm diameter
mounting hole
(minimum 60mm depth)
35mm diameter LED
mounting board thickness
must be at least 12mm
• This Kit contains LEDs that are non-replaceable
Bulb Replacement
Care and Cleaning
• We recommend cleaning with a soft dry cloth.
• Do not use solvents or abrasive cleaners as these
could damage the finish.
• To prolong the life and keep your outdoor lighting in
good condition, it is recommended that periodically
it is cleaned using a soft cloth followed by the
application of a light coating of oil, such as WD40.
• Do not clean the units with a pressure washer.
