Sawyer Manufacturing Company
7799 S. Regency Dr., Tulsa, OK 74131 USA
F
918.834.0318
P
918.834.2550
sawyermfg.com
V1.2
1
.
Adjust mounting arms
(F, Fig. 5)
to appropriate
pipe/tube size.
Note: Small slashed numbers = pipe
Large slashed numbers = tube
Operation
Fig. 5
1”
1/2”
F
Fig. 6
Fig. 7
Fig. 8
Fig. 10
Fig. 11
Fig. 12
D
A
I
H
G
N
S
E
W
2
.
Mount Quick Set machine to pipe/tube. Clamp boomer
(E, Fig. 6)
around pipe.
Note: When latch is fully extended, 1” = large spring. 1/2” = small spring
Note: To mount quick set to middle of pipe/tube undo the saddle arm locking
pin. (M, Fig. 4)
3. Torch arm Setup
A. Adjust torch arm assembly
(D, Fig. 7)
by loosening
the 9/16” nut.
(A, Fig. 7)
A-1. Adjust torch arm assembly
(D, Fig. 7)
to most
southern point.
Note: for short barrel torches you may need to move the
torch arm assembly halfway between north & south.
A-2. Tighten 9/16” nut.
(A, Fig. 7)
Tip: Place torch in torch holder to aide in setup.
B. Bevel angle adjustment.
(H, Fig. 8)
B-1. Loosen bevel indicator square nut.
(I, Fig. 9)
B-2. Adjust to desired bevel angle.
(H, Fig. 8)
B-3. Tighten bevel indicator square nut.
(I, Fig. 9)
Tip: use ½” wrench.
C.
Position adjustment.
(K, Fig. 10)
C-1. Loosen position adjustment knob.
(K, Fig. 10)
C-2. Move assembly to desired position.
C-3. Tighten position adjustment knob.
(K, Fig. 10)
D.
Install torch inside torch holder.
D-1. Loosen adjustment knob.
(G, Fig. 12)
D-2. Install torch inside torch holder.
D-3. Tighten adjustment knob.
(G, Fig. 12)
Fig. 9
E
K
