20
TSG-FDC OWNER’S MANUAL
ADJUSTING YOUR
FLOATING DUST COLLECTION GUARD
PAGES:
20-22
Adjusting the Dust Tube Parallelism
Adjusting the Dust Tube Length
1
1
2
If the dust tubes are not parallel with
the front and back of the table, the
parallelism will need to be adjusted.
Ensure the floating blade guard
is locked in its retracted position.
Next, release the dust tube lock
knob and pivot the dust tubes
towards the rear of the table.
Loosen the inner dust tube lock
knob by turning the handle counter-
clockwise and slide the inner dust
tube in or out of the outer dust tube
until the desired position of the
floating blade guard is reached.
Loosen the 5/16”-18 nut using a
1/2” wrench and thread the
5/16”-18 x 1-1/2” hex head bolt in
or out relative to the dust collection
guard mounting bracket. Once the
bolt is in the correct position, use a
1/2” wrench to re-tighten the nut in
order to secure the bolt.
