11
SLIDING CROSSCUT TABLE INSTALLATION
15. Use a 5mm allen wrench to slightly loosen the crosscut fence from the miter gauge as shown in
Fig. 7
.
Do not
loosen the screws more than 1 ½ full turn
. With the blade guard installed, raise the saw blade to the highest
elevation and tilt it to 45 degrees. Pivot the crosscut fence until it is parallel to the front edge of the saw. Slide the
crosscut fence to the right until the right side of the crosscut fence is about 2 inches from the left side of the blade
guard. If you want to position the crosscut fence closer to the blade, be careful not to run the crosscut fence into
the blade guard or anti-kickback pawls during operation. Retighten the screws.
16. Pivot the crosscut fence clockwise until the right end of the long slot on the crosscut fence is off the saw
table. Remove the T-bolt (229) from the Crosscut Fence Lock Knob and insert the threaded shaft of the T-bolt
up through the slot. Pivot the fence counterclockwise and slide the T-bolt into the T-slot in the right side of
the sliding table top as shown in
Fig. 8
. Place the plastic washer (228) on the T-bolt threaded shaft and then
screw on the crosscut fence lock knob. Do not tighten the lock knob at this time.
Fig. 7
Fig. 8
WITH
EXTENSION WING
INSTALLING
WITH
THE EXTENSION WING
Summary of Contents for tsa-sa48
