14
RT-LFT/RT-DCB OWNER’S MANUAL
ASSEMBLING THE DOWNDRAFT
DUST COLLECTION BOX
PAGES:
14-17
Requires:
Downdraft Dust Collection Box (RT-DCB) Hardware
Downdraft Dust Collection Box Parts
Phillips
Screwdriver
10mm
Wrench
The Downdraft Dust Collection Box is compatible with all SawStop Router Tables, and all
have the same installation procedure.
27” x 16” Table shown for reference.
1
2
Assemble the Downdraft Dust
Collection Box upside down (so the
bottom panel is on top). The front,
rear, and side panels each have two
bent edges extending in opposite
directions. The top edges have
elongated holes, and the bottom
edges have circular holes. The
bottom edges will extend internally,
and will serve as the mounting face
for the bottom panel.
Mount the front, side, and rear panels
(2.3, 2.2, and 2.1) to the bottom panel
(2.4) using ten truss head Phillips
screws (2.5). Tighten the screws with
a Phillips screwdriver.
The side panels are identical, and can
be installed on either side, although
different components come pre-
installed on each one. Decide which
side(s) you want your dust hose and
power cord to extend from, and make
sure you install the panels that way.
Refer to the note on page 16 and
ensure that the motor cover on your
saw does not interfere with the dust
port splitter if you are installing your
router table in-line on your saw.
Top
Bottom
2.4
2.2
2.2
2.3
2.1
2.5
