SawStop PCS31230, Owner'S Manual

Page: 97 / 123

SawStop 10” Professional Cabinet Saw 95
Auxiliary Fence Construction
B
A
B
A
24"
2”
24"
5 1/2”
(3/4” thick) (1/2” thick)
S STOP
This diagram illustrates a typical auxiliary fence for use with the push block shown on page 96. Cut piece
A
out
of
3
⁄ 4
inch thick hardwood
and cut piece B out of
1
⁄
2
inch
thick plywood. Position piece A
along the edge of piece
B as shown in the drawing above, and attach it using wood glue and counter-sunk wood screws.
Squares are 1 inch.
T
o
use the auxiliary fence, place it on the saw with piece B
fl
at on the table top and
piece
A
against the left side of the rip fence. Position the auxiliary fence so that the front
edge of piece B is 1-2 inches back from the front edge of the table, and then clamp piece
A
securely to the rip fence. Position the rip fence so that the spacing between
the left edge of piece B and the blade is the width you want to cut, and then lock the rip fence in place. Slide the workpiece along the edge of piece B closest to the blade. If your hand comes within 6 inches of the blade, remove your hand from the workpiece and use the push block to
fi
nish the cut, as shown in the drawing to the left.