How to Replace the Brake
Cartridge
The following shows how to replace a brake cartridge.
to learn how to replace a cartridge
after an activation.)
Use only the CTS-compatible version TSBC-10R3
of the brake cartridge. (Check the part number
and suitability on packaging.) Previous versions
of the brake cartridge are not compatible with
the Compact Table Saw.
Always turn off and unplug the saw when
working on or maintaining the saw.
1. Open the dust shroud door: use a flat-blade
screwdriver or similar tool to release the latch.
2. With the blade fully raised and the insert removed,
pivot the dust shroud door open.
3. Turn the cartridge key 90
°
clockwise.
4. Remove the cartridge key.
5. Remove the cartridge.
6. Install the new cartridge.
7. Install the cartridge key.
8. Turn the cartridge key 90
°
counterclockwise to lock.
9. Close the cartridge access door.
10. Install the insert and blade guard, or riving knife.
What to do After a Brake
Activation
If you contact the spinning blade, the spring inside the
brake cartridge releases and forces the braking pawl
into the blade. The blade and cartridge are sacrificed
to protect you. This is an activation. This also means
you must replace both the cartridge and the blade.
Always turn off and unplug the saw when
working on or maintaining the saw.
!
!
!
38
|
SawStop
®
Compact Table Saw
