ENGLISH
5
Power
Pre-run Timer /
Mode
Up
Light
WARNING
Always check that there is no combustible
material, like towels, above the heater, nor
inside the safety distances, before switching
the heater on! The safety distances are stated
in the heater manual.
2.2 Directions of use
2.2.1 Heater on
Press the Power button to activate the
heater. The heater LED is illuminated
indicating that the heater is turned on.
The sauna will heat up to the temperature
of the previous setting and operate for the
length of previous session time. Session
time is saved for next session only if
session time is changed within 5 minutes
after switching the heater on.
2.2.2 Heater off
Turn the heater off by pressing the Power
button. This button will turn off all the
active functions, including the pre-run
session. However, the sauna room light will
not be switched off. Light button can be
used even the heater is off. Also Fan.
2.2.3 Pre-run button
Pre-run button can only be enabled in
Off Mode. During the pre-run, parameter
values can be changed.
Set the pre-run time by pressing the Pre-
run button. A countdown time is displayed.
Use the Up and Down arrow keys to
change the pre-run values. After pre-run
time expires, the control will be in On Mode
where heater is switched on.
Next, temperature, fan*, steamer* and
session time (*not in all models) can be
changed if preferred. Finally long press
the toggle button to confirm.
When the control unit is in the pre-run
state, it will display the remaining time
of the pre-run. The confirmed pre-run
settings are saved for the next session.
The pre-run function has different default
settings, depending on the installation
location. For domestic use, the default time
is 6 hours, including the pre-run time as
well as the session time.
