Sawo CIR2-30NB, Manual, Page: 9 / 28

C
A
1900
450
150
B
830
SIDE VIEW
305
D
WALL MOUNTING TOP VIEW
CIR2-30NB
CIR2-40NB
CIR2-50NB
CIR2-60NB
CIR3-45NB
CIR3-60NB
CIR3-75NB
CIR3-90NB
200
200
275
300
250
300
350
400
100
100
100
100
100
100
125
125
A B
75
75
75
100
75
100
100
125
150
150
150
175
230
255
255
280
C D
250
250
300
350
300
350
400
450
100
100
100
100
100
100
100
100
A B
75
75
75
100
75
100
100
125
C D
Built-in Controls
Separate Control Unit
Wall Mounting Rack Installation
CIR2-30NS
CIR2-40NS
CIR2-50NS
CIR2-60NS
CIR3-45NS
CIR3-60NS
CIR3-75NS
CIR3-90NS
150
150
150
175
230
255
255
280
A B
HEATER INSTALLATION
It is recommended that the heater be placed on the wall nearest to the door. The air circulation
created by the door should work together with the hot air generated by the heater. For safety
and convenience, follow the minimum safety distances as provided (See Fig 1.). Follow the cubic
volumes (See page 11). Do not install the heater to the floor or wall niche. Install only one heater
in a sauna room.
Be sure to build a strong foundation for the mounting rack (e.g. cross struts in sauna paneling) or
reinforce the wall with a thick board to prevent the heater from collapsing. Attach the heater to the
wall with the aid of the mounting rack. Screws (6 pieces) are provided for fastening of the rack to
the wall. To affix the heater to the rack, lift the heater and fit the nuts that are placed at the back
of the heater to the slots on both sides at the top of the rack. Lock at least one of the side screws
to prevent the heater from being accidentally moved.
A certified electrician must do the installation of the heater to ensure safety and reliability. Improper
electrical connections can cause electric shock or fire. Refer to the electrical diagram See page 10.
Kuva 2
Fig. 2
An electrical supply cable must be connected to the terminal block inside the control unit through
the cable channel. The cable must be H07RN-F type or its equivalent. To connect the cable, the
control unit must be opened (See Figure 2). First, pull the temperature knob outward to uncover the
screws that hold the plastic cover. Second, remove the set of screws under the temperature knob
and at the bottom (both sides) of the control unit. Detach the front plastic cover and finally insert
the electrical supply cable into the cable channel by simply slipping it through the hole at the bottom
of the channel towards the opening at the other end (See Figure 2). Install the cables tightly to the
terminal block. Put back the front plastic cover, screws and temperature knob.
The heater gets very hot. To avoid the risk of accidental contact with the heater, it is recommended
that a heater guard be provided. Reserve enough space for operation of the timer and thermostat
knobs.
Leikkaa Kaapelin kiinnike
Slice the Cable Clip
Takaa
Back Side
ENGLISH
9