Sawn
Craft
Micro
B
‐
58
Manual
3)
Lay
the
vertical
stabilizer
on
the
table
with
the
bottom
facing
you.
Carefully
crack
the
rudder
along
the
rudder
line
or
use
a
straight
edge
ruler
and
a
hobby
knife
to
cut
down
the
rudder
cut
line
in
order
to
separate
the
rudder.
4)
Lay
the
rudder
on
the
table
with
the
leading
edge
facing
you.
Use
a
straight
edge
ruler
and
a
hobby
knife
to
cut
an
approximate
45°
bevel
into
the
leading
edge
of
the
control
surface,
ensuring
that
the
bevel
is
on
the
correct
side.
If
you
choose
to
use
a
glue
hinge
for
your
surfaces
ensure
you
bevel
the
mating
surface
as
well.
5)
Place
the
vertical
stabilizer
and
rudder
back
together
with
trailing
and
leading
edges
touching,
oriented
the
proper
direction
for
the
bevel
to
face
to
the
left
when
installed.
Cut
approx.
¼”
x
1”
pieces
of
hinge
tape.
Use
two
of
these
small
pieces
of
tape
to
attach
the
smooth
sides
of
the
rudder
and
vertical
stab
together.
Dry
fit
a
micro
control
horn
into
the
slot,
ensuring
that
the
hinge
bevel
is
facing
down.
Set
assembly
aside.
Tape
hinge
6)
Place
the
elevator
and
main
wing
together
with
trailing
and
leading
edges
touching,
oriented
such
that
the
hinge
bevel
faces
down
when
the
KFm
Step
is
facing
up.
Use
two
small
pieces
of
tape
on
each
elevator
half
to
attach
the
smooth
sides
of
the
elevator
halves
and
main
wing
together.
Page
7
140927
Micro
B
‐
58
Manual.docx
