8
Figure 14
11. INSTALLING THE
SWITCH HOUSING
NOTE:
Before starting installation,
disconnect the power by turning off the
circuit breaker or removing the fuse at
fuse box. Turning power off using the fan
switch is not sufficient to prevent electric
shock.
1. Remove the screws from the mounting
plate under the fan motor.
2. While holding the switch housing under
your fan, snap together the wire
connection plug. (Figure 14)
3. Carefully push all wires back into the
switch housing, then install the switch
housing onto the mountimg plate with
4 screws provided. Be sure to tighten all
screws. (Fig. 14)
12. OPERATING YOUR FAN
NOTE:
Wait for fan to stop before
changing the setting of the slide switch.
Turn on the power and check the
operation of your fan. The pull chain
controls the fan speed as follows:
1 pulls-High, 2 pulls-Medium, 3 pulls- Low,
and 4 pulls-Off.
Speed settings for warm or cool weather
depend on factors such as the room size,
ceiling height, number of fans and so on.
The slide switch controls directions:
forward (switch left) or reverse (switch
right)
Warm weather - (Forward) A downward
airflow creates a cooling effect as shown
in Fig. 15. This allows you to set your
air conditioner on a warmer setting
without affecting your comfort.
Cool weather - (Reverse) An upward
airflow moves warm air off the ceiling
area as shown in Fig. 16. This allows you
to set your heating unit on a cooler
setting without affecting your comfort.
Figure 15
Figure 16
Mounting plate
Connection plug
Screws
Switch housing