REMEMBER
to turn off the power. Follow
the steps below to hang your fan properly.
NOTE:
This ceiling fan is supplied with two
types of hanging assemblies; the standard
ceiling installation using the downrod with
ball and socket mounting and the "close-
to-ceiling"installation. The "close-to-ceiling"
installation is recommended in rooms with
less than 8-feet ceilings or in areas where
additional space is desired from the floor to
the fan blades.
STANDARD CEILING INSTALLATION
Step 1.
Pass the 120-volt supply wires
through the center hole in the ceiling
hanger bracket as shown in Fig. 5.
Step 2.
Secure the hanger bracket to the
ceiling outlet box with the screws and
washers provided with your outlet box.
Step 3.
Remove the hitch pin, lock pin and
set screws from the top of the motor
assembly.
Step 4.
Route wires exiting from the top
of the fan motor through the coupling
cover and canopy and then through the
ball/ downrod. (Fig. 6)
Step 5.
Align the holes at the bottom of
the downrod with the holes in the collar
on top of the motor housing (Fig.6).
Carefully insert the hitch pin through the
holes in the collar and downrod. Be
careful not to jam the pin against the
wiring inside the downrod. Insert the
locking pin through the hole near the end
of the hitch pin until it snaps into its
locked position, as noted in the circle inset
of Fig. 6.
Step 6.
Tighten two set screws on top of
the fan motor firmly. (Fig. 6)
Step 7.
Place the downrod ball into the
hanger bracket socket. (Fig. 7)
5. HANGING THE FAN
4
Figure 5
Figure 6
Figure 7
Registration slot
Downrod
Canopy
Set screws
Lock pin
Hitch pin
Canopy cover
Coupling cover
Tab
Mounting screws
(supplied with
electrical box)
CUL Listed
electrical box
Hanger
bracket
