9
10. INSTALLING THE
LIGHT KIT
NOTE:
Before starting installation,
disconnect the power by turning off the
circuit breaker or removing the fuse at
fuse box. Turning power off using the fan
switch is not sufficient to prevent electric
shock.
Step 1.
While holding the light kit
assembly under the fan, snap together the
wire connection plugs. (Figure 18)
Step 2.
Carefully push all wires back into
the mounting plate. Install the light kit
assembly onto the mounting plate with
the mounting screws provided. Be sure to
tighten all screws. (Figure 18)
Step 3.
Install the two 60W candelabra
bulbs (included). (Figure 18)
Step 4.
Raise glass shade up against the
light kit and secure it to fan by turning
glass clockwise until snug. Do not
overtighten. Restore power and your light
kit is ready for operation. (Figure 18)
Figure 18
Figure 19
Mounting plate
Wire connection
plugs
Light kit
assembly
Bulbs
Glass
shade
Srews
11. FAN WITHOUT LIGHT
KIT
(OPTIONAL)
1. Disassemble the switch housing from
the light kit by removing nut and washer
on the center of switch housing, you can
keep the light kit for future use.
2. Attach the plastic plug to the switch
housing. (Fig. 19)
3. Install the switch housing to the
mounting plate with screws provided. (Fig.
19)
Mounting plate
Switch housing
Plastic plug
Screws
