8
Figure 14
Figure 15
10. INSTALLATING THE
FAN BLADES
1. Attach the blades to the blade arms using
three screws and fiber washers as shown in
Figure 15. Start a screw into the arm, do not
tighten. Repeat for the 2 remaining screws
and washers.
2. Tighten each screw securely starting with
the center screw. Make sure the blade is
straight.
3. Fasten the blade assembly to the motor
using the motor screws provided. (Fig. 15)
9. FINISHING THE
INSTALLATION
Step 1.
Tuck connections neatly into ceiling
outlet box.
Step 2.
Slide the canopy up to hanger
bracket and place the key hole on the canopy
over the screw on the hanger bracket, turn
canopy until it locks in place at the narrow
section of the key holes. (Fig. 14)
Step 3.
Align the circular hole on canopy with
the remaining hole on the hanger bracket,
secure by tightening the two set screws.
Warning:
Make sure tab at bottom of hanger
bracket is properly seated in groove of
hanger ball before attaching canopy to
bracket. Failure to properly seat tab in groove
could cause damage to electrical wiring.
Outlet box
Hanger
bracket
Canopy
Screws
Screws
Screws and
fiber washers
Blade arm
Blade
