RT-2VSE & RT-2VSHO Operator Manual
2
BEFORE INSTALLATION
NOTE: Upon receipt of this unit, immediately unpack and inspect for possible concealed shipping damage. If unit
is found to be damaged, save all packing materials and contact your delivery carrier within 5 days. Refer to
“Shipping Damage Instructions” enclosed for detailed instructions. Failure to follow these instructions will negate
Savory’s or your ability to file claims and receive compensation for shipping damage.
This manual contains important safety and installation-operation instructions. Require all operators to read this
manual before using the unit. Failure to follow the instructions contained in this manual may cause injury, damage
to the unit, and will void the warranty.
INSTALLATION
Install this unit in the most convenient location for ease of cleaning, maintenance and general operation. Avoid
installing in locations with drafts, close proximity to grease or vapor-producing appliances or other high ambient
heat equipment. Allow approximately 1” clearance on sides and back of unit for proper air circulation. Allow
sufficient overhead clearance for proper heat dissipation. This toaster must be level for proper operation and
comes equipped with 1” adjustable legs for this purpose. (See enclosed instruction sheet for details.)
Before operating this unit, be sure that the following two components are properly installed:
1. The reflector tray is installed below the lower heating elements before shipping. It merely slides under the
conveyor belt. NOTE: Proper toasting cannot be performed if reflector tray is not installed.
2. The toast receiving tray is packaged separately and must be installed before operating this unit. Slide the
receiving tray into the toaster cavity below the control panel, making sure the slotted end is towards the back.
Place the slotted end over the two protruding pins located at the rear of the toaster cavity
(see figure 1).
ELECTRICAL SPECIFICATIONS – RT-2VSE
VOLTAGE
(Volts AC)
AMPERAGE
(Amps)
MAX. POWER
(KW)
FREQUENCY
(HZ)
PHASE
CORD
(Attached)
PLUG
(Attached)
208
15.4 3.2 50/60
1
3’
NEMA
6-20P
220
14.5 3.2 50/60
1
3’
NEMA
6-20P
240
13.3 3.2 50/60
1
3’
NEMA
6-20P
ELECTRICAL SPECIFICATIONS – RT-2VSHO
VOLTAGE
(Volts AC)
AMPERAGE
(Amps)
MAX. POWER
(KW)
FREQUENCY
(HZ)
PHASE
CORD
(Attached)
PLUG
(Attached)
208
19.5 4.0 50/60
1
3’
NEMA
6-30P
220
18.4 4.0 50/60
1
3’
NEMA
6-30P
240
16.9 4.0 50/60
1
3’
NEMA
6-30P
This toaster must be used with proper
voltage as specified on the unit data
plate located on the rear panel of
toaster. Use of any other voltage or
altering plug will damage unit, void
warranty, and may cause injury.
!
WARNING!
