EN
9
9
PREPARATION OF THE FRAME FOR THE HOOD IN
RECYCLING VERSION
In case the hood is used in recycling version it is
necessary to prepare the frame with all the necessary
connection pieces. In order to make the installation
easier it is necessary to lengthen the frame:
• Unscrew the two screws
2.1
fixing the upper
chimney to the frame and pull the chimney out.
• Unscrew the four safety screws placed at the top in
the frame separation area. (
A
).
• Unscrew the eight metric screws connecting the two
columns, placed on both sides of the frame (
B
).
Installation of components in recycling version:
• Fix the recycling air outlet piece
15
to the upper part
of the frame using four
12c
screws supplied with the
hood.
• Fix the flange (ø120)
10
to the lower part of the
recycling air outlet
15
.
• Put the reducer flange
9
on the hood body outlet.
• At this point, join the flanges with a pipe. In order to
calculate the height of the pipe it is necessary to
estimate the height of the hood (mm) and subtract
615 mm. (H pipe = H hood-615).
• Lengthen the frame so that the pipe can be inserted.
Place the pipe between the two flanges and block it.
Make sure that the height of the frame is correct
considering the height of the cooker hood (H frame =
H hood – 184). Adjust the height of the frame and
tighten again the earlier removed screws. Tighten
again the safety screws in order to give more stability
to the structure.
• Fix the pipe with the pipe clamps
25
.
A
B
15
12c
10